Spray instruction

For modeling use only. 

Observe the technical sheet. Pre-filled canister with special propelling gases and other substances.

The ink color on the cap matches the final product.

Application: 

1. Sand base, clean, prime. 
2. Shake the can well for at least 2 minutes. 
3. Check color tone. 
4. Apply 1-2 coats with intervals of 5 minutes ofintermediate drying time. 
5. Allows overcoating with all conventional 1K and 2K clearcoats, after a drying time of approx. 15 to 20 minutes

Health and Safety :

•  Danger. Contains acetone. Extremely flammable aerosol. 
• Pressurized container may burst if heated. 
• Causes serious eye irritation. 
• May cause drowsiness or dizziness. 
• If necessary, consult a doctor and show him the package or the label. Keep out of the reach of children. 
• Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition. 
• Do not pierce or burn, even after use. 
• Use only outdoors or in well-ventilated areas.
• IF IN EYES, rinse cautiously with water for several minutes. If you wear contact lenses, remove them if possible. Continue rinsing. 
• If you feel unwell, contact an ANTI-POISON INFORMATION CENTER/Doctor. 
• If eye irritation persists, consult a physician.Keep out of the sun. 
• Do not expose to temperatures above 50°C/122°F. Dispose of contents/container in accordance with local/regional/national /international legislation. Insufficient ventilation allows the formation of potentially explosive mixtures. 
• Attention! Hazardous inhalable droplets may form when spraying. 
• Do not breathe spray or mist. do not store in living rooms or bedrooms.
• Use only as intended.