
Order summary
Your cart is currently empty.
Add 399,99€ EUR to your shopping cart to get free shipping using the shipping method CTT Internacional ** .
Products
0
0,00€ EUR
Shipping
0,00€ EUR
Total
0,00€ EUR
- Home
- Informação
- Spray instruction
Spray instruction
For modeling use only.
Observe the technical sheet. Pre-filled canister with special propelling gases and other substances.
The ink color on the cap matches the final product.

Application:
- Sand base, clean, prime.
- Shake the can well for at least 2 minutes.
- Check color tone.
- Apply 1-2 coats with intervals of 5 minutes ofintermediate drying time.
- Allows overcoating with all conventional 1K and 2K clearcoats, after a drying time of approx. 15 to 20 minutes
Health and Safety :
- Danger. Contains acetone. Extremely flammable aerosol.
- Pressurized container may burst if heated.
- Causes serious eye irritation.
- May cause drowsiness or dizziness.
- If necessary, consult a doctor and show him the package or the label. Keep out of the reach of children.
- Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition.
- Do not pierce or burn, even after use.
- Use only outdoors or in well-ventilated areas.
- IF IN EYES, rinse cautiously with water for several minutes. If you wear contact lenses, remove them if possible. Continue rinsing.
- If you feel unwell, contact an ANTI-POISON INFORMATION CENTER/Doctor.
- If eye irritation persists, consult a physician.Keep out of the sun.
- Do not expose to temperatures above 50°C/122°F. Dispose of contents/container in accordance with local/regional/national /international legislation. Insufficient ventilation allows the formation of potentially explosive mixtures.
- Attention! Hazardous inhalable droplets may form when spraying.
- Do not breathe spray or mist. do not store in living rooms or bedrooms.
- Use only as intended.